Causes and Solutions of drip in beer filling machine1

Beer filling machine sometimes there will be a case of drip, which may be related to the use of methods, beer filling machine are attached with instructions, in accordance with the beer filling machine operating instructions to debug the machine, generally, the dripping situation can be solved. If the operation error is eliminated, it is possible to fill the equipment. Next, we will introduce the causes and solutions of the dripping of the beer filling machine. The causes and solutions of drip in beer filling machine: 1. The causes of drip in beer filling machine may be that the O-ring in beer filling machine is corroded or worn seriously. This requires us to repair the O-ring. 2. It is also possible that the ball valve in the beer filling head is damaged or lax. At this time, we need to check the ball valve in the filling head. If the ball valve in the filling head is damaged, the ball valve needs to be replaced. 3. Observe whether the orifice of the filling nozzle of the beer filling machine is damaged. For this phenomenon, we need to repair or replace the filling nozzle orifice, the diameter of the orifice can not be greater than 7. 5mm. After fixing the aperture, gently smooth the plane of the orifice on the water mill sandpaper. 4. Beer filling machine if there is liquid leakage from the liquid outlet at the lower end of the piston, the cylinder should be disassembled and the random sealing ring should be replaced. But this place needs to pay attention to the sealing ring with & phi; 65 ×3. 1 acid and alkali resistant sealing ring. The above is the solution to the drip of the beer filling machine. For the drip of the filling machine, it must be handled in time to avoid unnecessary losses!