Debugging operation process of filling quantity of beer filling machine

When the beer filling machine is turned on, the first thing to do is to debug the filling volume of the beer filling machine. This is to prevent the beer filling machine from causing various problems during operation and causing unnecessary losses. The debugging operation process of the filling quantity of the beer filling machine is as follows: 1. First, loosen the nut and then adjust the screw to change the position of the lower fixed rod. Therefore, the push-pull length of the syringe is also changed to achieve the purpose of free adjustment of the packing quantity. The screw is adjusted clockwise as the increment, otherwise it is reduced, and the Middle pointer is indicated. Use a 5ml needle tube to look at the side marked with 5 ml, use a 10ml needle tube to look at the side marked with 10 ml, and directly look at the scale and pointer quantification for models 20, 100 and 500, however, due to the different thickness of each needle tube, there is an error in the actual packing amount. The needle tube scale shall prevail, and the zui can also be measured with a measuring cup at the beginning of packing. 2. Tighten the nut immediately after adjustment to make the lower fixing Rod and crank firm. 3. Loosen the nut and press different syringe push-pull lengths to determine the correct position of the upper fixing rod. After the lower fixing rod is adjusted, turn the crank to make the syringe turn to the upper dead center, and then lift the outer sleeve of the syringe up about 2mm to avoid cracking the needle tube, and then tighten the nut before starting the machine. 4. Turn on the switch after the machine is correctly assembled. When the machine is working, the crank drives the syringe to pull the liquid up and down, adjust the speed knob, select the appropriate sub-assembly speed, start working normally, and adjust the governor knob, the speed of clockwise packing is fast, whereas the speed is slow. The debugging of the filling quantity of the beer filling machine is to fix the filling quantity in a relatively correct position, so that when the beer filling machine is used, it will not be overfilled.