Failure and solution of filling machine manufacturer

The large-dose liquid filling machine of the filling machine manufacturer is always easy to encounter some common faults in its work. If these faults occur, you will not repair them. Can only be anxious and so on, not only wasting production time, but also bringing losses to production. The following trano packaging equipment introduces some common faults and maintenance skills of large-dose liquid filling machines: faults of filling machine manufacturers 1: when large-dose liquid filling machines are filled with large specifications, the feeding tank is insufficient, resulting in unstable liquid level. Cause filling is not allowed. Solution: increase the amount of feeding or re-close the small ball valve, and reset the filling time of the high-dose liquid filling machine (Longer filling time)Slow down the filling speed to solve. Failure 2 of the filling machine manufacturer: If the high-dose liquid filling machine adjusts the digital dial code or unit, the time will not change. Solution: turn off the power and turn on the power again. Failure 3 of the filling machine manufacturer: If the high-dose liquid filling machine encounters the problems of sufficient feeding in the tank, stable liquid level and inaccurate filling quantity. Solution: it may be that the filling channel is blocked by debris in the large-dose liquid filling machine. Check the inlet of the trough or in the filling mouth to clean the debris. Failure of filling machine manufacturer 4: If the high-dose liquid filling machine encounters the problem of dripping after closing and stopping liquid filling. Solution: 1. The orifice of the filling nozzle may be damaged. The filling nozzle can be taken out to trim the orifice. The diameter of the orifice cannot be greater than 7. 5mm. After repairing the aperture, gently flatten the surface of the orifice on the water sanding paper. 2. The ball valve in the filling head is damaged and needs to be replaced. Failure of filling machine manufacturer 5: If the high-dose liquid filling machine does not fill after touching the injection switch, the time relay digital indicator LED does not flash. Solution: it is possible that the injection switch is damaged or the time relay base is loose. Replace the same type of injection switch or press the time relay base. Failure of filling machine manufacturer 6: If the high-dose liquid filling machine does not fill after touching the injection switch, but the digital LED indicator of the time relay flashes. Solution: 1. Check whether there is air pressure or whether the air pressure is too low. If it does not meet the air pressure requirements, we should adjust it in time and then start the machine for observation. 2. If the air pressure meets the requirements, it may be that the solenoid valve coil is damaged or the pneumatic valve core is stuck by stolen goods. You can unplug the power supply, open the plate, and use the object to rotate or press the button next to the corresponding solenoid valve coil, if the valve can change direction, it means that the solenoid valve coil is damaged. If it cannot change direction, the valve core is stuck and the solenoid valve coil can be replaced or the decomposed valve can be repaired. The failure of the filling machine is the last thing all users want to meet, but contrary to their wishes, the large-dose liquid filling machine will always encounter some filling machine failures in the actual filling production. The light can be solved by itself, and the heavy one needs to be repaired. In addition to the normal maintenance of the high-dose liquid filling machine, we also need to know the common faults of the filling machine so as to properly handle the faults. : Filling machine manufacturer