Faults and solutions of filling machine manufacturers

Filling machine manufacturers of large dose liquid filling machine work is always easy to encounter some common failures, if these failures you will not repair. It can only be anxious and so on, which not only wastes the production time, but also brings losses to the production. The following trano packaging equipment introduces some common faults and maintenance skills of large-dose liquid filling machines: faults of filling machine manufacturers 1: when large-dose liquid filling machines are filled with large specifications, the feeding tank is insufficient, resulting in unstable liquid level. Resulting in inaccurate filling. Solution: The filling amount can be increased or the small ball valve can be closed again to reset the filling time of the large-dose liquid filling machine (Lengthen the filling time)Slow down the filling speed to solve. Failure 2 of filling machine manufacturer: if the large dose liquid filling machine adjusts the digital dial code or unit, the time will not change. Solution: turn off the power and turn on the power again. Failure 3 of the filling machine manufacturer: if the large-dose liquid filling machine encounters sufficient feeding in the trough, the liquid level is stable, and the filling quantity is not accurate. Solution: it may be that the large dose liquid filling machine has sundries blocking the filling channel. Check the entrance of the material trough or in the filling mouth, and clean up the sundries. Failure 4 of the filling machine manufacturer: if the large-dose liquid filling machine encounters the problem of dripping after closing and stopping the liquid filling. Solution: 1. The orifice of the filling nozzle may be damaged. The orifice can be taken out and trimmed. The diameter of the orifice cannot be greater than 7. 5mm. After fixing the aperture, gently smooth the plane of the orifice on the water mill sandpaper. 2. The ball valve in the filling head is damaged and needs to be replaced. Failure 5 of the filling machine manufacturer: If the high-dose liquid filling machine does not fill the material after touching the injection switch, the digital indication LED of the time relay will not flash. Solution: it may be that the injection switch is damaged or the base of the time relay is loose. Replace the same type of injection switch or press the base of the time relay. Failure 6 of the filling machine manufacturer: If the high-dose liquid filling machine touches the injection switch, it will not be filled, but the digital LED indicator light of the time relay flashes. Solution: 1. Check whether there is air pressure or whether the air pressure is too low. If it does not meet the air pressure requirements, we should adjust it in time and then start it up for observation. 2. If the air pressure meets the requirements, it may be that the solenoid valve coil is damaged or the pneumatic valve core is stuck with stolen goods. You can pull off the power supply, open the board, rotate with objects or press the button next to the corresponding solenoid valve coil, if the valve can change direction, it means that the solenoid valve coil is damaged. If it cannot change direction, the valve core is stuck. The solenoid valve coil can be replaced or the valve can be decomposed for repair. The failure of the filling machine is the last thing all users want to meet, but contrary to their wishes, the large-dose liquid filling machine will always encounter some failure of the filling machine in the actual filling production. The lighter can solve it by himself, while the heavier need maintenance. In addition to the normal maintenance of the large-dose liquid filling machine, we also need to know the common faults of the filling machine so that we can properly handle it when we encounter faults.