Filling machine installation should pay attention to what the error will appear what problem

if you want to improve the working efficiency of the filling machine, be sure to correct operation and use of equipment, correct installation equipment to make it work properly. In order to ensure the quality of the equipment installation, filling machine manufacturer introduce everyone to equipment installation and improper operation will have problems.

　　1. After installation of the machine, adjust feeding track and bottles receiving tray to a level ( Tighten the set screws) 。
　　2. Liquid storage tank has been full of liquid.
　　3. The filling machine of all electrical switch in the closed position.
　　4. Will fill the bottle into the toolkit ( Each machine is equipped with 20 toolbox box) 。
　　5. If connect external power outlet of the three core, and has reliable grounding line, in order to prevent the leakage of box and hit people.
　　6. Open the machine power switch, the power indicator light will be lighted, indicates that it has been opened.
　　7. Support plate support filling aircraft using filler. The purpose is to prevent the adjustment and fill the screen down while filling. Will be cleaning liquid container on filling head below.
　　8. Fingers upward push filling head positioning sleeve. Positioning sleeve to provide the flexibility to move up and down, and filling the needle to reveal or retract without blocking.
　　9. Transfer liquid storage barrel at the bottom of the switch to the opening location, so that the liquid can flow into the main metering pump. In filling machine installation, therefore, need to pay more attention to the installation of small make up the above mentioned points, and after the installation of the equipment for the quality inspection of detail work, to ensure that the installation of equipment. Quality is no problem.
of course, filling machine and other mechanical equipment are the same, once the operating error, will inevitably lead to some faults, thus affect the normal use of equipment, equipment life and even loss. To introduce the equipment under the improper operation will encounter problems:
1. The main function of the programmable controller is a relay contact glue dots. Failure phenomenon is after the start signal motor running, but the signal to stop the motor did not stop. When the PLC closing, motor to stop.
　　2. Proximity switch failure, failure and the reasons for fixing the blade fall off. It does not match with the objects packaging. Rising fixing blade and proximity switch lose signal. When the blade protection plate contact packaging, fixing the blade automatically back up.
　　3. Electromagnetic switch after the fault and the fault mainly for cylinder does not work, because the cylinder too fast and electromagnetic switch can't detect signals. If the bag on roll too fast, the reset push after the bag, the bag fixing knife roller will not be able to work.
　　4. Electromagnetic valve failure mainly for cylinder does not work or not, and the cause of the solenoid valve is cylinder or discharge air solenoid valve can change direction. If the solenoid valve leakage, as a result of inlet and exhaust channel connection, can not meet the pressure of the filling machine. When work pressure is reached, the beam blade will not rise in position.

the filling machine to is to introduce the above equipment installation operation, once the equipment is used, the problems at the same time, indicates operation there may be a problem. At this time, should be more attention, hope to help you!