Little knowledge of beer filling machine and its cleaning and maintenance

installation note
1. After open the packing machine, please check whether the attached technical data are complete and whether the machine in the process of transportation damage, so as to timely repair.
　　2. According to the diagram to install and adjust the manual into the paper and the paper components.
　　3. In each lubrication point to add a new lubricant.
　　4. Use blender rotating machine, to check whether the machine direction is correct, and machines are grounded.

the beer filling machine principle
how it works: filling machine is semi-automatic piston type filling machine. Cylinder piston operation to extract and discharge materials, one-way valve used to control the flow of materials, and the reed switch is used to control the cylinder stroke to adjust the volume of fill.
　　1. Loosen the set screw up and down, to unload the liquid injection system for regular disinfection, or open it for separate disinfection and cleaning.
　　2. Will start into the tube in the cleaning fluid and cleaning.
　　3. 500 ml model the actual filling would be wrong, so before the formal filling, gas cylinders to accurately.
　　4. Type filling machine needles, used in 10 standard 5 ml or 10 ml syringe, for 20 of 20 ml glass filler, 100 ml glass filler used in type 100.

the beer filling machine maintenance operation specification
1. To do a good job of cleaning and disinfection of beer filling machine, keep the beer filling machine surface clean, often eliminate accumulation of material in the beer filling machine, and keep the equipment clean.
　　2. Check equipment of each station die position, if there is a deviation and adjust the position.
　　3. Examine each one fixed component fixed environment. If loose, please repair immediately.
　　4. With lubricating oil beer filling body, and each sliding mechanism.
　　5. Check engine wear environment of timing belt, timing belt replacement of damaged, will the belt tensioning mechanism to adjust to the right size.
　　6. Check whether the sensor probe can be normal use.
　　7. Check the air pressure and adjust.
　　8. Check the triangle clip washer, if there are any damage, please change.

the above introduction is the knowledge of beer filling machine, beer filling machine maintenance is also to do well, especially with beer direct or indirect contact with pipes, cleaning maintenance, must be applied to clean with water every day, every time a week wash and disinfect.